uPVC Ready For Use 1k Paint - Brush On or Spray On

Coverage:

250ml: x1 exterior door with 1 coat or x2 windows with 2 coats

500ml: x1 exterior door with 2 coats or x4 windows with 2 coats

1L: x2 exterior door with 2 coats or x8 windows with 2 coats

2.5L: x4 exterior door with 2 coats or x16 windows with 2 coats

5L: x8 exterior door with 2 coats or x32 windows with 2 coats

A 1K Vinyl Acrylic with exceptional flexibility and adhesion. HMG PVC 17 is suitable for coating most PVCu, hard plastics (not GRP) and powder-coated surfaces (architectural cladding). If in doubt, a small trial should be carried out in a localised area to ensure adhesion and compatibility with the surface. PVC17 is not suitable for coating areas incorporating draught seals and gaskets.

Technical Properties

Coverage

10.5 square metres per litre @ 20 microns dft

Flashpoint

-9 °C

Storage

Store between 5°C - 25°C. When not in use, cans must be kept sealed

Shelf Life

12 months from delivery date in original sealed containers

Maximum VOC Content

0.745 Kg/l

Regulations

2004/42 IIB (E) 840

Colour Range

Available in a wide colour range including RAL & BS and Automotive shades

Cleaning

Ensure surfaces to be coated are dry and must be cleaned using the appropriate HMG product to remove all traces of contaminants. HMG produce a full range of cleaners, silicone removers, degreasers and preparatory cleaners suitable for the cleaning process. Please refer to our website for Knowledge Base article Prep-Cleaning Techniques (KNB0009) and Preparatory Cleaners from the Product Guide.

Surface Preparation

Please refer to Knowledge Base for details on Surface Preparation. PVC curtain material and other flexible substrates are best coated after they have been aired, to ensure that any trapped plasticisers can escape. These need to be released/removed from the surface to ensure correct adhesion and drying of PVC 17. Failure to remove plasticiser will cause adhesion and drying problems. New PVC curtain material and other flexible substrates should be exposed to the atmosphere for at least 7 days to ensure optimum adhesion and drying performance. HMG produce Prep Clean 2805 & 2806 for use on new & old substrates

Additional Information

**In cases where large areas are being sprayed and where the temperature is exceeding 25 degrees C, 2604 slow thinner may be used to increase wet edge time**

CLICK THE IMAGE BELOW FOR YOUR READY FOR USE PAINT - PRETHINNED SO YOU DON'T HAVE

CLICK THE IMAGE BELOW FOR GREY SCOTCH PADS - P600 GRIT

CLICK THE IMAGE BELOW FOR RED SCOTCH PADS - P320 GRIT