Product

Manufactured from galvanized mild steel. Spiral duct cowl is a component fitting of Spiraduct system. Fittings slot inside duct. Sizes are nominal. Actual appearance/scale of product may vary dependent on size. Item is designed small/male ended to slot into stated pipe diameter.

Please adhere to building regulations or consult a qualified professional for suitability and specific installation guidance.  These are professional building products used industry wide. 

SDS Fixing screws (not supplied with cowl unless purchased)
No 4.2x13mm Square drive. Manufactured from hardened mild steel, bright zinc-plated

Driver bits if required are available to purchase here

*** PLEASE NOTE - If you purchase ONLY SDS Fixing Screws you will only receive SDS Fixing screws *** 

Uses

For use in a wide range of air, dust, fume and particle applications. Used to terminate a spiral ducting stack.