Latex Mould To Make Detailed 3D Lion Head Wall Plaque for Plaster or Concrete

Bestselling Lion Head Mould

Latex Mould To Make This Lion Head 3D Wall Art Plaque  

Super looking mould to create a large Lion Head Wall Plaque. Loads of detail on the mane, a very striking piece.

This mould can be used time and time again using powder, plaster or resin. Look after it and it will look after you. Just wash it after use, dry it (inside and out), add a little anti bacterial talcum powder and store in a safe dry place. Usually black latex.

Great large size - approx 25cm x 20cm

You can paint him or leave him natural. Add some colour or glitter to the mix, the choice is yours. Use plaster for inside use or concrete for outside use.

HOW TO USE:

You can use plaster of Paris, fine casting powder, cement. concrete, wax, or soap in our moulds. Resin will break down the latex, check your label for details.

Most moulds will need some support, this can be done by embedding the moulds into a bucket of sand.

Once supported simply pour your mix into the mould, give it a little shake to bring any air bubbles to the top, then just leave to completely dry and set hard.

To remove I find it easiest to dust the outside of the mould with talc and gently roll the mould off the cast. Then leave for a few days (plaster) or several days (cement) to completely dry out. You can then paint it, you may need to use a spray primer first. Once painted, seal with spray varnish so its weatherproof.

LOOKING AFTER YOUR MOULDS

Wash out moulds in warm soapy water, allow to completely dry, then give a dusting of talc inside and out and store somewhere dry. Looking after your moulds will give you years of use from them.

Our moulds are hand made to order, they are fresh and new for you, so please allow up to 14 days for despatch.

You cant rush a good mould

Please look at my other moulds

Any questions just ask.

I am happy to ship worldwide