Hot Sale
AG-2.0 Professional MTB bicycle Derailleur Hanger Alignment Gauge rear change ear correction tail hook Bike repair tool
Color: red + blackMaterial: aluminum alloy + stainless steelUse range: 26/27.5/29/700CShrinkage length 235mm stretch length 388mmRotation angle: 360°Applicable models: most bicycles360° rotation, with a new structure, telescopic measurement, more convenient and faster, smaller size and lighter weight.Versatile, durable and durable;300 stainless steel high temperature resistant 800 °c to maintain the inherent corrosion resistance of stainless steel is more durable than other common calibration toolsGuide rods can be moved automatically, can be taken out, easy to measurePackage Contents:1* Derailleur Hanger Alignment GaugeInstall:
1.The part 1 into the indicator bracket corresponding end.
2.Sliding handle into the part 1 corresponding position lock good nut.
3.The part 3 into the corresponding position of part 4,set such as O-ring.
Instructions:
1.Install wheel in frame.Make sure rim is Correctly centered in frame.
2.Remove derailleur from derailleurHanger.
3.Thread inside shaft(Ref# 1)into derail-Leur mounting hoie.
4.move indicator so tip of indicator contacts outside Edge of rim(position A).
5.Move sliding bracket so indicator is clear of rim.Then rotate tool 180 degrees to position C.
6.Move sliding bracket and indicator to outside edge Of rim.If tip of indicator iswitin 4mm of outside,Edge of rim,the hanger is aligned horizontally.If tip Of Indicator is 4mm or more away from rim,or if indicator presses against rim,the hanger is missal-igned.Move slid-ing bracket and indicator so they are clear of rim.Then Inner shaft and correction correction handle(Ref# 1)as a lever to bend hanger into alignment horizontally.Repeat checking and bending betweenpositins A and C until clearance is less than 4mm.
7.After achieving correct horizontal alignment,keep indicator In same position and rotate to position B.lf
clearance.Between outer edge of rim and tip of indicator is lees than 4mm,rotate tool to position D.If clearance is greater than 4mm,Or if indicator presses against rim at position B or D,use Inner shaft and correction correction handle As a,lever to align hanger vertically.
8.With properly aligned hanger,tip of indicator should just contact Outer edge of rim at one position and have no more than 4mm Clearance at any of the other positions.Check and align all four Positions until is accomplished.
Hot Sale
On Apr 28, 2024 at 00:47:12 PDT, seller added the following information: