These replacement decal are two layers thick vinyl.

Brushed silver then printed and a clear vinyl overlay applied. This not only protects the print but makes the decal thicker more like the original quality.

All the major holes are cut for the switches and knobs.  The 4 holes for the meter mounting and the 4 holes for the top face mounting screws  can be easily poked . These  are fully covered anyway and only done this way to ease the installation.  This way you only have to worry about lining up the switches , knob holes and leds.

I like to fold the top and bottom 1/2" over.  This will prevent the top and bottom chipping that you're original may suffer from. Due the the rounded bend in the face metal.  The extra 1/2" on the sides can be easily trimmed off with razer knife following the edge.

Often times the top 2 on each side face mounting screws and the washer around it are starting to rust . So I'm including 4 screw cap covers that I use on my rebuilds. (See pics).

Also by request I'll include 1 to 3 covers the will work for the knobs. Not the best but only solution I have for a missing knob center cap.

Again let me know if you want me to include any of these! As I have a limited supply.

73