● Product Name: Solar Cell Solar Panel Module
● Material: epoxy resin + Conductive copper strip+ Solar cells + PCB base plate
● Solar Technology: Polycrystalline
● Voltage: 2V 3V 5V 5.5V 6V 9V 10V 12V
● Power Source: Solar
● Types
With Wire 0.24W 2V 120mA
With Wire 0.3W 5V 60mA
With Wire 1W 6V 180mA
With Wire 1.15W 5.5V 230mA
With Wire 1.2W 3V 400mA
With Wire 1.3W 5.5V 240mA
With Wire 1.9W 5V 380mA
With Wire 1.9W 6V 320mA
With Wire 3W 10V 300mA
0.26W 2V 130mA
0.37W 3V 125mA
0.5W 4V 130mA
0.63W 3V 210mA
0.8W 5.5V 150mA
0.9W 6V 150mA
1.3W 5.5V 240mA
1.5W 6V 250mA
3W 10V 300mA
3.3W 6V 550mA

Parameter Description
1. Due to the Fact That the Output Power of Solar Panels Depends on Factors Such As Solar Irradiance and Solar Panel Temperature, Measurements of Solar Panels Are Carried out Under Standard Conditions, Defined As Atmospheric Mass Am1.5, Light Intensity 1000w/M2, and Temperature 25 ℃.
2. Under This Condition, the Maximum Power Output by the Solar Panel Is Called Peak Power (Rated Power). in Many Cases, the Peak Power of the Component Is Usually Measured Using a Solar Simulator. in Practical Use, Due to the Insufficient Intensity of Sunlight to Meet the Testing Conditions, the Peak Power Is Generally Not Achieved.
3. the Nominal Rated Voltage and Rated Current Are the Peak Voltage and Current That Can Be Achieved Under Test Light Intensity and Temperature When Connected to a Load. in Actual Use, Even in the Hot and Spicy Sunlight at Noon in Summer, the Test Conditions Cannot Be Met. Therefore, There Is a Relationship Between:
Open Circuit Voltage (Without Load)＞rated Voltage＞actual Working Voltage
Short Circuit Current (Output Short Circuit)＞rated Current＞actual Working Current
The Main Factors Affecting the Output Performance of Solar Panels Are As Follows:
(1) Load Impedance
(2) Sunlight Intensity
(3) Temperature
(4) Lighting Angle and Lighting Area

Product Features
The Solar Panel Is Packaged by Laser Cutting the Solar Cells into Small Pieces, Producing the Required Voltage and Current. Due to Its Small Size, Packaging Methods Similar to Solar Photovoltaic Modules Are Generally Not Used. Instead, the Solar Cells Are Covered with Epoxy Resin and Bonded to the PCB Circuit Board, Which Has the Characteristics of Fast Production Speed, Pressure Resistance and Corrosion Resistance, Crystal Clear and Beautiful Appearance, and Low Cost.

Product Application
Suitable for Home Device Power Supply, Solar Panel Phone Power Supply, Solar Phone Power Bank, Solar Lamp, Solar Toy DIY Production, Solar Tourism Power Supply, DIY Equipment, and so on