Feature:

The MAX7219 is an integrated serial input / output common-cathode display driver, it is connected to a microprocessor with 8-digit 7-segment digital LED display can also be connected to the bar graph display

or 64 separate LED. On B BCD encoder including an on-chip, multi-channel scanning loop word drive,

but also an 8 x 8 static RAM is used to store each data. Only one external register is used to set the current of each LED segment. A convenient four-wire serial interface can connect all general-purpose microprocessor. Each data can be addressed in the update does not need to rewrite all the display. MAX7219 also allows the user to select on each data coding or non-coding.

The entire device contains a 150μA low-power shutdown mode, analog and digital brightness control, a scan-limit

register allows the user to display the 1-8 bits of data, as well as a let all LED light detection mode.

Only need three IO ports can drive a dot-matrix! Dot-matrix display, flicker-free! Supports cascading!

This price is the price of the DIY kit, need to DIY yourself.

Disclaimer: All components are brand new, PCB board after all the test stand test to ensure the physical well-

connected. The welded risk once welding, do not accept returns. But can help customers free commissioning, repair,return shipping costs borne by the customer!

Module parameters:

1. single module can drive an 8 * 8 common cathode lattice

2. module operating voltage: 5V

3.Module size: 5 cm in length X width 3.2 cm x 1.5 cm

4. with four screws hole, aperture 3mm, Our M3 Tongzhu fixed

5. modules with input and output interface, supports multiple modules cascade

Wiring instructions:

1.Module on the left as an input port, output port on the right.

2.Control of a single module, simply input port to the CPU

3. more modules cascade input termination module of a CPU,

2 output termination module input and output of the two

modules is terminated with the input end of the first three modules, and so on. ..

51 MCU, for example:

VCC → 5V

GND → GND

DIN → P22

CS → P21

CLK → P20

Note:

1.VCC and GND is not reversed, it would burn the chip!

2. the P0 port control 51 microcontroller must be connected to the pull-up resistor, it is recommended that the resistance of 4.7K--10K

3.Please lattice first inserted into the round hole seat, then inserted into the round hole Block PCB board welding. Lattice word side facing the surface order from left to right pin 123456. PCB board 1 foot square pad!

4. as cathode of the electrolytic capacitors long-legged, short legs for the negative; ceramic capacitors without the positive and negative points.

Package include:

1 x Bausatz DIY LED MAX7219 Dot Matrix 8x8 Module für Arduino MCU Control Module

Packed Safely in Bubble Bag.