Welcome to my store Items detailsKindly notice, this wireless relay switch is learning code type, can pair extra remote. If you need extra remote, you can choose "extra remote"-----> " add to card"--> "continue shopping", then choose other variation to to buy. Application Three working mode, suitable for Home automation/ light, motor control/ garage doors & opener/ DIY/ Project and so on. Receiving Board parameters Operating Voltage: AC220V Operating Frequency: 315MHz Receiver Sensitivity: >-105dB Maximum Load: 10A 250V AC Encoding Type: learning code(Can link many remote at the same time) Control Channel: NC/NO About 40g Remote control parameters Operating voltage: 12V (12V 23A battery) Frequency: 315MHZ Encoding Type: Fixed code Firing Range: 100 meter(open) in theory, 15%-30% in reality Size: 35x x 55mm x 13mm Shock resistance : 4.7M Battery for transmitter :23A 12V(Packing list Not include the batteries, the air mail ban it.) Packing List: Variation 1: Board + Remote + cover Variation 2: Remote Usage and manual Just use your imagination to your project and home automation Three working way. self-lock means toggle: Press-> On, Press again ->Off inching means momentary: Press->On, Release->Off inter-lock means Latched: Press->On, Release -> On(Press other key off) About changing the working mode 1)Short time press the button of receiving board(about 5 seconds), LED flashes once -->Monentary Mode 2)Short time press the button of board(about 5 seconds)again, LED flashes twice -->interlock mode 3)Short time press the button of board(about 5 seconds)again, LED flashes three times -->self-locking mode repeat and cycle the working mode. About linking the extra remotes Press the the button of the receiving board, about 2 seconds, and the indicator light up, release the button, the receiving board is into the linking mode. then press A key of the remote, the indicator flashes,(difference working mode should press B key again, the indicator flashes again) the linking is successful. About clearing the linking information Long time press the button of receiving board(about 15 seconds), and then the LED flashing. the board will be back to factory mode, you can link again. Shipping
|