Features: 1. Frequency range :0.05M-550MHz, 2. Stepping : 1Hz 3. Output signal strength : 4dBm 4. Logarithmic Dynamic range: better than 50db 5. Linear detection range :0-1V EMF 6. Interface : USB, BNC, SMA 7. Power Supply : DC11.5-12.5V / 0,5 A 8. Control Software : WINNWT4 V4.08.02 9. Size::40.5*97*178mm 10. Features: supports logarithmic , linear detection, with 0-50DB attenuator ,Capable of impedance , VSWR ( impedance VSWR bridge need to meet with ) other functions measurement 11. 4-layer design FAQ 1.What is this,anything used Sweep is frequencycharacteristictester,is a test set,test compent frequency and amplifiler curve,suh as test a LC tank frequency and amplifiler curve. NWT serial sweep is digital sweep,small step,connect PC calculation data,can VFO output.smaller lighter than the old sweep.NWT4000-1,NWT4000-2 can used simple spectrum analyzer Check USB driver ,check extern DC power,check software setting . Can test,duplexer is a filter.Frequency sweep meter is connected to the output of the duplexer antenna terminal and receiving terminal,frequency sweep meter input end connected machines, can be measured Used SWR bridge or three port connect. Used the swr bridge can be measured in Bobbi, can qualitative measurement, need to pay attention, frequency sweep meter can only used of bridge with the RF output, not with the bridge band detection output three port connect. Used three port connect replace swr bridge ,can test antenna ,only for compare test. According to USB2.0 protocol the current is 0.5A,is enough.if power supply is not enough,check USB cable connect is good,change a high quality USB cable,change to USB 3.0 port(current is 0.9A),used a extern power supply USB HUB. The impedance mismatch, power is not 100% transmission, reflection. will cause the measured parameters (gain, fluctuation, insertion loss, bandwidth) and other parameters are incorrect, can consider the external transformer or resistance as impedance matching, then measure insert the attenuator in the instrument input and output, attenuator normaly is 3DB, if you want to be more precise, can be replaced by 10DB or higher number attenuator, the disadvantage is loss of dynamic. 1 x NWT500-BNC 0.05M-550MHz Amplitude-frequency characteristic analyzer Sweeper |