ULTRA HIGH ACCURACY TEMPERATURE SENSOR MODULE – TS001UH

PRODUCT INFO:

ULTRA HIGH ACCURACY AND RESOLUTION
Using NXP SE95D:
±1ºC from -25~100ºC (Worst-Case)
0.03125ºC res.

EASY-TO-USE I2C INTERFACE
2-line serial I2C-bus interface
Upto 8 TS001 modules on the same bus
Bus fault timeout to prevent hang ups
Capable of 20 Hz ~ 400 kHz communication
Bread Board Friendly

APPLICATION RECOMMENDATION
TS001 has been designed to minimize the temperature difference between the IC’s sensing diode and the PCB.
To measure the ambient temperature place the module separated from any heat source and its power planes.
To measure the temperature of a heat source place the module directly on a power plane of the heat source.

#4 standoffs and screws can be used for installation.

TS001s have default I2C 7-bit address of 0x4F.
1 0 0 | 1 X X X
A6 A5 A4 | A3 A2 A1 A0
Last 3 LSB bits – A2, A1, and A0 are customizable on board. They are defaulted to ‘1’, but you may solder-joint / short the address jumpers to set them to ‘0’ (ex with A0 shorted, the address will be 0x4E).

PIN DESCRIPTION
( ) ( ) ( ) ( ) ( )
SDA SCL OS GND VIN

SDA: Digital I/O; I 2 C-bus serial bidirectional data line; pulled up to VIN
SCL: Digital Input; I 2 C-bus serial clock input; pulled up to V IN
OS: Over-temperature shutdown output; open-drain output; fully customizable threshold, hysteresis, and logic
GND: System ground input
VIN: System power input

RECOMMENDED OPERATING CONDITIONS
VIN 2.8 ~ 5.5V
TAMB -55 ~ +125ºC

For more detailed information, please refer to NXP SE95 datasheets and application notes.

SHIPPING INFO

The items you ordered will be shipped out in 1 business day by Canada Post.
To anywhere in Canada, estimated delivery time is from 2 to 6 days.
To anywhere in USA, estimated delivery time is from 5 to 8 days.
To anywhere Worldwide, estimated delivery time is from 6 to 10 days.

Bulk shipping/unit price is available.

Please note that we are not responsible for tax or any other customs payments.

We accept returns within 14 days.

Each module is tested before leaving our office. It will be packed inside anti-static bag and bubble wrap envelop for protections.

ABOUT FRIENDLY DESIGN STUDIO

POWER PROTECTIONS
Protecting you and your investment is important for us. To prevent any possible damage TS001 has built-in:
Over-Current Protection
Over-Voltage Protection
Reverse Polarity Protection

QUALITY DESIGN
TS001 is designed to optimize:
Accuracy – maximized primary thermal paths to the sensor
Convenience – added onboard customizable address jumpers

QUALITY PARTS
No cheap knockoffs!
Our products only use high quality parts from NXP, Panasonic, Murata, and more.

TECHNICAL SUPPORT
Got software and hardware questions?

Our team of friendly engineers is available to assist you with any of our products.

friendlydesignsquare@gmail.com

MADE IN CANADA/USA