Emblems Are made of High Quality 3D Embossed Aircraft Thin Aluminum and then Specially Hard Anodized for a Long Lasting Finish . Each Emblem Comes with 3M Self Adhesive Tape for Easy Installation. Just Peel and Stick. You can install these emblems on the trunk, fenders, interior dash, laptops, ipad cases Iphone, samsung phones and more. 

Measures: Approx. 5" Long x 1 1/4" Tall. 1/64" thick

As always, professional installation is recommended; however, we have provided a general set of guidelines to aid with the installation. 

Suggested tools for this installation: Step 1 

Removing old emblem or emblems can done neatly by using a heat gun on the lowest setting. Carefully pry the old emblem off using a putty scraper. 

Step 2 

Then clean the area where the emblem adhesive still remains. Use adhesive cleaner and a clean rag. 

Step 3 

Most important step is to use rubbing alcohol on a different rag to clean the remaining grease or dirt from the location. Allow it to air dry. 

Step 4 

Using a level or ruler to create a straight line parallel to the ground, marking the location of the emblem against desired surface or body lines. Use painter’s tape to make your guide lines. 

Step 5 

Prepare the emblem, making sure it's clean. Be sure to never touch the application adhesive on the back of the emblem after Remove the backing tape from the adhesive. 

Step 6 

Hold the emblem just above the surface in the desired location, using the painter’s tape as a guide to keep the emblem level located properly. 

Step 7 

Stick the emblem on and hold it in place until the adhesive has had a chance to setup bond on the surface of the vehicle. This usually takes 10 seconds.. 
Curing time for the adhesive is 24 hours. Do not let water or any other liquid get on the emblem or else the adhesive bond will be damaged.