quantity:1pc

20AX2 / 40Ax2 Brushless ESC Dual two-way mixed control RC Boat tanks 2S-4S Lipo

Parameters:

Two-way Blushless Mixed Control Electric Tuning

20A parameter

Voltage: 7.4-16.8V (adapted to 2-4S lithium)

Each continuous current: 20A, instantaneous current: 30A (10 seconds)

40A parameter

Voltage: 7.4-25.2V (adapted to 2-6S lithium)

Each continuous current: 40A, instantaneous current: 60A

BEC: Efficient DC-DC solution, 5V 2-3A (can be 2A long-distance running, no other UBEC insertion on the receiver, if 3A is not enough, contact the shopkeeper)

Overheat protection

Out of control protection (loss of signal for 1 second, motor shutdown)

The method of use is the same as the brush double mixed electric adjustment in our shop. The middle point of the throttle is electrically mediated.

(If the motor turns slightly after unlocking, please use remote control throttle/direction fine-tuning to stop the motor)

According to the open source firmware tips, when debugging, you must not take an oar! (Keep the oars in the cage at all times and keep your body absolutely safe)

There are two modes

Mixed control mode (default) (throttle/steering mode): 2 or 3 channels (recommended 2 channels, because 2 channels return automatically) control throttle, 1 channel (or 4 channels) control differential steering, throttle ratio 100%, steering ratio 100%, steering priority. Suitable for: Tanks (in this mode, Three Channels control can play with tanks), speed difference ships,

Two-way synchronization (single yellow line suspended): In this mode, two motors are synchronized by throttle control.

Main points of debugging:

First determine the direction of forward and backward motor. (That is, no single yellow wire is inserted to determine whether the positive or negative of the motor is OK)

Then adjust the direction (insert a single yellow line), if not in line with expectations, it may be that the remote control is reversed, set back.

Someone asked: not with out-of-control protection, why do I turn off the motor?

This is because when you turn off the receiver will output a low throttle signal. Low throttle is backward for power regulation, and full speed backward.

After shutdown, the receiver automatically outputs low throttle signal, also known as out-of-control protection.

There are three solutions

1) The throttle is connected to 2 channels, and the 2 channels out of control protection is generally 1 500 (if not, please set up), indicating stop.

2) According to the standard process, switch off the model power supply before the remote control power supply.

3) If you use 3 channels, set the 3 channels out of control protection to 1500

Important Reminder: The out-of-control protection of throttle passage (generally: 2/3 passage) is set to 1500, 1500 is stopped for two-way electric regulation.

Payment Policy :

We only accept payments via PayPal.

Shipping Time & Method:

Item will be shipped within 3 days after payment is confirmed. Goods will be sent via airmail .

Delivery takes about 18-25 business day (without holidays). All products have been checked and packaged in good condition before dispatch.

Please make sure your address in PayPal is matched with your shipping address before pay. If you would like to change the address, please contact us IMMEDIATELY after your payment.

Return policy :

After receiving item. 30 days can return Items must be the original packaging. No use. No damage. Buyers bear the freight cost.