Untitled DocumentMetric Hand Taps HSS (Set of three)M7x0.75 mm Pitch .
Tapping drill Size 6.25 mm(for information only)
Top Industrial Quality Tools !!!!
HAND TAPS (ISO 529)
These are NEW professional quality ground finish straight flute general purpose tools which can be used for both machine or hand tapping. They are generally the most economical tool for use on production runs, but are best on materials that produce chips, or where the swarf breaks readily. Where deep holes are to be tapped, in materials which produce stringy swarf, other types of taps may be needed, especially for coarse threads.
Hand taps can be supplied in sets of three; bottom, second and taper leads, or individually (please enquire).
BOTTOM TAPS have a chamfer (lead) of 1–2 threads, the angle of the lead being around 18 degrees per side. They are used to produce threads close to the bottom of blind holes.
![](https://www.davethetools.com/ebay/var/resizes/V-Coil/Volkel%20Plug%20Lead.jpg?m=1316345419)
SECOND TAPS have a lead of 3-5 threads at 8 degrees per side. They are the most popular and can be used for through holes, or blind holes where the thread does not need to go right to the bottom.
![](https://www.davethetools.com/ebay/var/resizes/V-Coil/Volkel%20Second%20lead.jpg?m=1316345419)
TAPER TAPS have a lead of 7-10 threads at 5 degrees per side. The taper lead distributes the cutting force over a large area, and the taper shape helps the thread to start. They can therefore be used to start a thread prior to use of second or bottom leads, or for through holes.
![](https://www.davethetools.com/ebay/var/thumbs/V-Coil/Volkel%20Taper.jpg?m=1316345420)
IMPORTANT NOTE ON TERMINOLOGY! In the U.K. bottom taps are often referred to as ‘plugs’. In North America second taps are often referred to as ‘plugs’! This can easily lead to confusion. To avoid problems when ordering it is best to use the terms bottom, second and taper.
Another variation is that second taps are sometimes referred to as ‘intermediate’, and taper taps can be called ‘firsts’.
Untitled Document
These are NEW professional quality ground finish straight flute general purpose tools which can be used for both machine or hand tapping. They are generally the most economical tool for use on production runs, but are best on materials that produce chips, or where the swarf breaks readily. Where deep holes are to be tapped, in materials which produce stringy swarf, other types of taps may be needed, especially for coarse threads. TAPER TAPS have a lead of 7-10 threads at 5 degrees per side. The taper lead distributes the cutting force over a large area, and the taper shape helps the thread to start. They can therefore be used to start a thread prior to use of second or bottom leads, or for through holes. IMPORTANT NOTE ON TERMINOLOGY! In the U.K. bottom taps are often referred to as ‘plu