Universal Outboard Motor Flush Muffs

For All Outboard Brands From 40 Hp And Above Hozelock Type Fitting

These motor flushers / flush muffs are an essential item to the maintenance of any outboard engine. It is advised to flush your engine after every trip, this applies to both salt and fresh water. These simple steps to flushing your engine will extend the life of you engine and prevent salt clogging the water cooling system and the corroding of internal parts. These are a great value product to prevent a costly engine failure due to sand, grit and salt.

FEATURES

Double flusher with rubber suction cups, Injection moulded plastic components, PVC hose and plated mild steel bracket. Suitable for most outboards and some sterndrive engines with water inlet on leg.
With hose connector at mid point for an even flush on both sides.
Simple installation by attaching to hose.  

FLUSHING YOUR OUTBOARD
Simply slip the flushers over the lower unit where the water is picked up and attach your hose to the connector.
Start the engine (on tick over) and allow the water to pump through for around 5 minutes.
Be sure to have an even flow of water but not too much pressure as the water will spurt out preventing a thorough flush.
Ensure to keep an eye on your outboard whilst running at all times and keep the hose from getting caught on the prop.
If you are flushing your engine at the end of season it is advised to disconnect your fuel line and allow the engine to burn all the fuel left in the carburetor.

COMPATIBLE WITH THE FOLLOWING OUTBOARD MODELS

    

MAKE	MODEL	YEARS
Evinrude	40 hp and above	-
Force	40 hp and above	-
Honda	40 hp and above	-
Johnson	40 hp and above	-
Mariner	40 hp and above	-
Mercury	40 hp and above	-
OMC	40 hp and above	-
Selva	40 hp and above	-
Suzuki	40 hp and above	-
Tohatsu	40 hp and above	-
Yamaha	40 hp and above	-