![](https://microcontrollershop.com/Images/rohsc.gif)
This low cost prototyping board for 40-pin PIC microcontrollers comes
mounted with a PIC18F452 microcontroller in a 40-pin DIP socket and
minimum support components, like a reset switch, crystal and power-on
LED. All microcontroller port pins are each routed to two
adjacent through-hole solder pads. Dedicated solder rows for Vcc &
GND help to simplify connections of your own components. A prototyping
area allows you to add your own circuitry. Use this board for your quick experiments and prototypes. Note:
This board does not have an on-board voltage regulator. You must use
this board with a regulated DC power supply. Exceeding 5.5VDC will
damage the components on this board. The universal supplies shown in
the options below do not have a 5V setting. You can use them, however,
in combination with one of the 5V regulator boards found in the Voltage Regulators Category. That category also has some USB-sourced options. PIC In-Circuit Programming This
board has a single row, male ICSP header for in-circuit programming of
the microcontoller. If your PIC programmer has a RJ12 connector use our
PIC-ICSP programming adapter (see add-on options below). PIC 40-pin DIP Prototype Board Downloads |