SPE-UV20W Universal LED Ultraviolet Dual Fixed Exposure Machine

This machine  adopts 20 pieces LED lamp beads imported from Korea, the total power is  20W (equal to 200W ordinary ultraviolet lamp effect), the wavelength is  365nm , the exposure machine opening irradiation size is 140* 100mm; LED  plate lamp beads can last 50,000 hours.

This machine is mainly used for exposing  in screen printing, pad printing, bronzing, etc. It can also be used for  curing products with wavelength of 365nm.

1.The light can rise and fall according to  the need , the minimum distance from bottom of the machine to the  surface of the desktop is 3 cm, the highest distance is 20 cm.

      4.The  machine adopts general voltage components, suitable for 90-230v voltage  use.

      5.In  order to facilitate the user to exposing, the machine is additionally  equipped with a flat 25*25 cm rubber plate with thickness of 2mm, a  glass chuck and a countdown timer.

The operation methods is as follows

1.Spread the black rubber on a flat table. 

  
2.Place the coating mesh frame on the rubber sheet, and stick the mesh  side to the rubber sheet.

3.Put the film on the top of the mesh exactly (in order to prevent the  film sliding, it is best to use a little transparent tape to stick the  film and the four sides of the mesh together);Use a glass sucker to lift  the glass and place it on the film;(This machine is not configured with  the glass for transportation safety, users can configure locally  according to the frequently used size, 4-5 mm glass plate is  appropriate).

4.Move the machine to the top of the screen frame. The distance between  the lower edge of the case and the screen frame is 3-5 cm.According to  the actual exposure time of photosensitive adhesive to set the countdown  time.

5.Turn on the power and start the countdown timer.

6.After the countdown, the timer beeps and lights off, remove the  machine, take out the glass and film, exposure is completed.

1*SPE-UV20W Universal LED Ultraviolet Dual  Fixed Exposure Machine