DESCRIPTION
The power cord is not included, please find one with at least 10A from your local market.
The APW3++ can deliver a maximum power of only 1200W if it is connected to a 110V mains power supply. To obtain the rated power of 1600W, the APW3++ must be connected to a 220-240V mains power supply. Please check the mains power supply that is the standard in your region before ordering.
This batch of PSU comes with only 10 PCIe connectors so cannot be used with more than one Antminer L3+ miner.
This Bitmain Power Supply was intended to be an AntMiner Power Supply and works with: AntMiner S9I, AntMiner S9 and all previous AntMiner models as well as the Avalon 841, 821 etc. It can be used as a power supply for GPU mining and will support up to 5 cards that use 2x 8 Pin Connectors for power and is one of the best power supplies for mining.
The shipping for this batch will start soon after 1st November 2017, depending on when the units are ready to ship out and your position in the order queue.
ADDITIONAL INFORMATION
WEIGHT | 6 lbs |
---|
DIMENSIONS | 13 × 7 × 5 in |
---|
OUTPUT - DC VOLTAGE | 12.15V |
---|
OUTPUT - RATED CURRENT(220V INPUT) | 133A |
---|
OUTPUT - RATED CURRENT(110V INPUT) | 100A |
---|
OUTPUT - RATED POWER(220V INPUT) | 1600W |
---|
OUTPUT - RATED POWER(110V INPUT) | 1200W |
---|
OUTPUT - RIPPLE & NOISE | <1% |
---|
OUTPUT - VOLTAGE REGULATION | <2% |
---|
OUTPUT - SOURCE REGULATION | <1% |
---|
OUTPUT - LOAD REGULATION | <1% |
---|
OUTPUT - SETUP, RISE TIME | <2S |
---|
OUTPUT - POWER OFF PROTECTION TRIP TIME | >9mS |
---|
OUTPUT - INTERFACE TYPE | 5 pairs of 6 pin PCI-E connectors (i.e. 10 connectors) |
---|
OUTPUT - NOISE LEVEL | <43DB |
---|
INPUT - VOLTAGE RANGE | 100-240V AC |
---|
INPUT - STARTING VOLTAGE | 95-105V AC |
---|
INPUT - FREQUENCY RANGE | 47-63Hz |
---|
INPUT - POWER FACTOR | >0.95 (full load) |
---|
INPUT - LEAKAGE CURRENT | <1.5mA (220V 50Hz) |
---|
PROTECTION - LOW-VOLTAGE INPUT | 80-89V AC |
---|
PROTECTION - OUTPUT SHORT CIRCUIT | Yes |
---|
PROTECTION - OUTPUT OVERCURRENT | 134-185A max. |
---|
PROTECTION - OVERHEAT PROTECTION | Yes |
---|
ENVIRONMENT CONDITIONS - OPERATING TEMPERATURE | -20°C – 50°C |
---|
ENVIRONMENT CONDITIONS - OPERATING HUMIDITY | 20% – 90% relative humidity (non-condensing) |
---|
DIMENSIONS | 220mm*108mm*62mm |
---|
COOLING FAN | Forced-air cooling |
---|