Note: This BMS is a custom model that comes pre assembled for easy install (no soldering needed) and is for LiFePO4, LiFe, or LFP batteries. Lithium-ion (Li-ion)/Lithium-polymer (LiPo) based BMS boards are in my other listings.

Description:

This BMS balance board is used for a lithium battery pack to equalize voltage and protect the cells. This module charges, discharges, balances, and acts as a low voltage/over charge cutoff.  We have pre installed a screw based connection block for the easy connection of balance wires to the BMS. The BMS is assembled to use a COMMON Port setup for both charge and discharge at 60A (continuous) and discharge at 120A (burst). 

The following is the BMS parts list:

(1) BMS Board LiFePO4 LiFe LFP

(2) Ring Terminal Connectors M3, 8-16AWG Wire Compatibility 

(2) Ring Terminal Screws and Washers

(1) Pre-installed balance wire connection block, 16-24AWG Wire Compatibility 

*Wires are not included. Balance wires of 16-24AWG will fit in the balance connection terminal and primary wires of 8-16AWG can be used in the ring connectors. Larger gauge primary wires can be used with larger ring connectors or solder points.

Battery compatibility: Voltage of 2.4V - 3.7V LiFePO4 battery types

Charging input voltage: 12V - 14.6V

Maximum starting current: 120A

Maximum continuous current: 60A

Charge current: 60A

Maximum continuous current (additional solder point): 100A

Board Size: approx. 42*60*7.4mm

Package includes: 1 x LiFePO4 Battery Protection Board

Condition is New. Shipped with USPS First Class.