Note: This BMS is a custom model that comes pre assembled for easy install (no soldering needed) and is for Lithium-ion (Li-ion) and certain Lithium-polymer (LiPo) batteries.  LiFePO4 based BMS boards are in my other listings.

Description:

This BMS balance board is used for a lithium battery pack to equalize voltage and protect the cells. This module charges, discharges, balances, and acts as a low voltage/over charge cutoff.  We have pre installed a screw based connection block for the easy connection of balance wires to the BMS. The BMS is assembled to use a COMMON Port setup for both charge and discharge at 60A (continuous) and discharge at 100A (burst). 


The following is the BMS parts list:

(1) BMS Board Lithium-ion (Li-ion), Lithium-polymer (LiPo)
(2) Ring Terminal Connectors M3, 8-16AWG Wire Compatibility 
(2) Ring Terminal Screws and Washers
(1) Pre-installed balance wire connection block, 16-24AWG Wire Compatibility 

*Wires are not included. Balance wires of 16-24AWG will fit in the balance connection terminal and primary wires of 8-16AWG can be used in the ring connectors. Larger gauge primary wires can be used with larger ring connectors or solder points.


Battery compatibility: Voltage of 2.5V - 4.2V lithium battery (18650, 26650, LiPo, Li-ion)
Charging input voltage: 16.8V
Maximum starting current: 100A
Maximum continuous current: 60A
Charge current: 60A
Maximum continuous current (additional solder point): 100A
Board Size: approx. 42*60*7.4mm
Package includes: 1 x Li-ion Lithium Battery Protection Board


Condition is New. Shipped with USPS First Class.