Set comes with highly-detailed replacements for all 4 engines' exhaust and supercharger areas

Designed to fit the 1/48 Monogram B-29 Superfortress kit.

3D printed with photo-etch (see below)

Some prior Experience handling 3D printed resin parts and PE is highly recommended

A few notes on 3D printed parts

A sharp hobby knife will also be needed to carefully remove the support structures.

Great care has been given to the design and build orientation to minimize layering and pesky support structure residue. It is recommended that the modeler take a slow and methodical approach here, to avoid broken resin parts.

While not super brittle, the resin parts will crack under pressure, and are not as resilient as injection molded plastic.

This seat took me about 10 minutes to free from the support structures. I recommend starting with using a razor saw to carefully detach from bottom float, and then carefully work your way around the sides, snipping off the supports with shears. Trim nubs with sharp #11 and some sandpaper if you wish, to finish.