1) The Linear Actuator is made of high-quality aluminum alloy material.

2) It is equipped with a strong 1000N motor, 12V input voltage and 3.8A maximum load current.

3) Linear Actuator Specification:

    Travel Speed = 0.39 inches/sec (10 mm/s)

    Stroke Length: 200mm (8")

    Retracted Length: 305mm (12")

    Extended Length: 505mm (20")

    Shaft: 20mm diameter

    Mounting Hole: 6mm diameter

4) Noise Level: 45~60dB

5) Built-in limit switch.

6) IP55-rated protection sealed against dust, water, and corrosion suitable for outdoor use.

7) Overcurrent protection, overload protection, and over-voltage protection.

8) It can be used to open doors, lift tables, raise flat screens, adjust recliners for the headset, footrests, relaxation beds, and floor cleaning machines, mobile traffic signs.

How To Install The Linear Actuator

1. Prepare to connect the two wires of the stroke linear actuator to a 12-volt battery.

2. Blue wire to the positive terminal and grey wire to the negative terminal will make the actuator extend. To make it retract, just reverse the terminal connections.

3. To simplify the last step, you can prepare a reverse polarity relay or switch (not included) for the actuator. When you want the actuator to extend and retract, just press the switch.

4. Your linear actuator will hold its position when the power is off. It will automatically stop when reaches the end.

5. The actuator has a pre-installed inner limit switch, it cannot be adjustable.

This Item Doesn't Come With Installation Guides. We Highly Recommend Professional Installation.