G Scale SL 6165011 Sound Unit Power Storage Buffer Booster 2.5F11V SCap w 3 wire plug for LGB 65xxx unit NEW
Plug and Play with any LGB 65xxx Sound module or Loco with 3 wire plug. The SL 6165011 has more power, 6X more efficient with DC to DC power conversion and is lower cost than the LGB 65011 unit..
Direct From the Manufacturer - Made in the USA
For analog operation, this
high-energy accessory powers the sound unit when the track power is low or off.
That lets you hear all the the standing sounds after the loco stops and
the sound does not cut off when the loco slows down.
Google SWL4 HOME for larger photos and product details
1 each SL 6165011 Sound Storage Unit and Buffer
Buy it now price: $99.95 New
Features:
Instructions:
For analog operation, this high-energy accessory powers the sound unit when the track power is off. That lets you hear the standing sounds after the loco stops.
Function:
- When the throttle is turned up, the Sound Unit Power Storage is recharged automatically.
- When track power is turned off, the Sound Unit Power Storage returns the energy to the sound circuit. The standing sounds are played.
- Hint: If this product is not used for a long time, its capacitors will discharge, and the sound system will operate erratically. To recharge the capacitors, operate the connected loco at brisk speed for about 30 seconds.
- Power Supply Attention! For safety and reliability, operate this product with SL power supplies (transformers, power packs and controls) only. The use of non SL power supplies may void your warranty. Use this product with SL or LGB power supplies with an output of at least 1 amp.
Specifications:
- 4 Each 10F (farad) super applicators for efficient power storage
- Each super capacitor can be recharged over 600,000 times
- A special active 230 ma current limiting circuit eliminates false triggering of short circuit protection
- Dimensions: 44mm L x 26mm W x 36mm H
- 3 pin plug with 2 gauge wire for easy plug and play operation and high current capacity
Photos:
Note the DC to DC converter that
eliminates the heat of other similar units and also increase efficiency
to up to 95% so even small starter set 1 amp supplies can be used with
the sound storage buffer.
Note that the sound storage buffer uses 4 each 10F super capacitors for playing sound with low or no track power.
The bottom of the buffer has a 3M peel and stick adhesive pad for easy mounting.
Plug the 3 conductor plug of the SL 6165011 into an LGB 65xxx sound module as shown above. (LGB sound module not included but is available at our store)
Set up in seconds for years of Locomotive sounds when your trains slow or stop!
Google SWL4 HOME for larger photos and product details
Thanks for looking - ShourtLine.com by Soft Works Ltd.
copyright 2022 Shourt Line - Soft Works Ltd. all rights reserved