3D Printing Cessna  Throttle - Mixture - Prop - Flaps - Trim Wheel controller for flight sims.  It is USB and no drivers are needed.  Just calibrate in Windows Control Panel, assign controls in game and ready to fly.  It uses a Arduino board inside and  It is using  linear slides and potentiometer. 

The throttle, prop and mixture are push-pull only controls.  The flap lever is 3 position momentary switch, push up to raise flaps one notch at a time, push down to lower flaps one notch at a time, the switch auto returns to center.  With Trim wheel for more realistic feel and 8 programable toggle switch .

• The controller work perfectly in Microsoft Flight Simulator 2020 and X-Plane and should work in any other flight sims/game as Arduino boards are used in many controllers and regarded as being high quality and very versatile.  Includes 6' USB cable, just plug it in and Windows  will recognize it without drivers.
•  Dimensions for the case :  200mm x 200 mm x 97mm ,with the Throttle pull out at 350mm x 200mm x 97mm.
• If you have any issues with the controller please contact me, I will go above and beyond to resolve any issues that may occur.  Thank you!