INTERIOR FOR THE jCONCEPTS CREEP CAB This listing is for the bench seats and dash / steering wheel components only. All parts will be printed in the same color.   

The interior was designed for maximum clearance those some trimming and adjustment may be required for larger transmissions. Optimal configuration is with a low profile transmission or transfer case.

Mounting: The dash and bench seats are designed to be mounted with 2x6mm screws. The hole separation has been imbedded into the print for easy reference. Alternatively you can fix them both with your choice of tape or glue.

Due to the nature of 3D printing, items may contain tiny visual blemishes. Items may require some trimming and painting for optimal visual appeal/fit; similar to what you would expect to do with model parts. Items that requred support material may still have some artifacts remaining on the underside of the print.


IMPORTANT: Do not use power drivers on 3D printed parts. Over tightening printed parts and cause premature cracking and crushing. Always ensure you hardware will not bottom out in the screw pocket. This can also cause at 3D printed part to break prematurely.

 

I am an Authorized Printing Partner for Spare-Time Hobbies.

I am exclusively Authorized to sell prints on E-Bay for all designs sold by Spare-Time Hobbies.

 

My authorization code is STH-EB101.

 

Concerns should be direct to Adam @ Spare-Time Hobbies 

 

Disclaimer:

Due to the nature of 3D printing, items may contain visual blemishes. 3D printed product may require some trimming, drilling and painting for optimal visual appeal and proper fit; similar to what you would expect to do with modeling parts. 3D printed parts are formed at or above 200 degrees Celsius. Do not store in high temperature areas or in direct sunlight.

 

Warranty:

If your 3D Printed product becomes damaged within the first 30 days, one set of individual replacement parts are available upon request. Please e-mail a photo of the damaged part for review to determine if design or print was the cause of damage. After the first 30 days, replacement is at the discretion of the 3D Printing Partner.