New Quartz Clock Repair Kit Movement Mechanism Motor & Coloured Hands & Fittings
REPLACEMENT MOVEMENT EASY ORDER SYSTEM
1 - Remove your old movement (Black box)
2 - Measure the spindle length (protruding Gold & plastic piece) and match to the chart below
|
MOVEMENT SHAFT TYPE |
SILVER THREAD LENGTH |
TOTAL SHAFT LENGTH |
TOTAL SHAFT WIDTH |
|
Short – For clock faces up to 4mm thick |
6.7mm |
14mm |
7.6mm |
|
Medium – For clock faces up to 9mm thick |
11.7mm |
19.5mm |
7.6mm |
|
Long – For clock faces up to 12mm thick |
15mm |
22mm |
7.6mm |
|
Extra-long – For clock faces up to 16mm thick |
20mm |
28mm |
7.6mm |
|
Supersize – For clock faces up to 22mm thick |
24mm |
32mm |
7.6mm |
3 – Decide on ticking or non-ticking
4 – Fill in your information in the drop-down box’s above
5 – Hangers can be removed on request
6 – Add the quantity required
7 – Then simply buy it now or add to basket to continue
- One movement and one set of hands available in 5 spindle sizes - Short, medium, long, Ex long & SUPERSIZE
- Ticking - Standard ticking
- Non ticking - Second hand sweeps rather than ticks for a quieter movement
- Movement dimensions - height 70mm ( 55mm with hanger removed ) - width 55mm - depth 16mm
- Press fit plastic hands in sizes 39mm - 120mm ( Please select above ) Hand measurement shown is taken from the centre of the minute hand hole to the tip of the minute hand
- Complete with all fixings
- The movement brand and shaft colour can change from the photo's attached and although the silver thread and OK888 movement is used with most orders this may change on some occasions but a compatible model will still be sent
- ROHS approved
- Hangers can be removed on request
- Fully tested
- Fitting instructions included
