Remote Start Controller Kit

For use in MEP-802A & MEP-803A Generators 

WiFi Remote Control & 2-Wire Start/Stop

Features include:

- 2-Wire Remote Start/Stop interface for use with ATS, Solar Charge Controller, or even a toggle switch.

- Remote Start/Stop via WIFI using a cell phone, laptop, tablet, etc. Anything with WiFi and a browser!

- Direct WiFi communication. No router needed. Works during power failures.

** Upon request they can be configured to connect up to your wireless router so that it can be accessed from any device on your routers network.  If this mode is desired you must send me an ebay message when ordering so that I can configure the controller before shipping.

- 300 foot plus WiFi range. Password protected

- Hundreds of systems currently in use across the USA and around the globe

- No extra parts to buy for different applications

- Browser display of all engine and generator operating parameters on remote WIFI device. Parameters nearing extremes are highlighted in red text.

--> Ambient Temperature
--> Battery Voltage
--> AC Voltage
--> AC Output Frequency
--> %Load
--> Fuel Level
--> Coolant Temperature
--> Oil Pressure

- Remotely Enable and Disable the Auxiliary Fuel Pump

- Remote control of the Contactor with the Contactor state displayed

- User calibration of all parameters

- Data Logging of all parameters as well as engine hours and Start/Stop count. Min, Average & Max values logged every 10 seconds.

- Two wire remote Start/Stop for use with ATS, Charge Controller or a basic switch

- Transfer between WIFI and Manual control while running

- Automatic Pre-Heat below 40 degrees F

- User programmable durations and delays for all phases of start up and shutdown. Separate settings for WiFi Start/Stop and 2 Wire Start/Stop

--> Pre-Heat duration

--> Fuel System prime duration

--> Cranking duration

--> Warm up

--> Stop command to contactor open delay

--> Cool down delay

- Antenna and connector are IP65 rated for water resistance.

- Retains full manual control of the generator thru it's front panel

- Controller is conformally coated to prevent corrosion

- Wire harness utilizes Mil Spec Air Frame wire rated to 300 F

- Includes Controller, wire harness, antenna, drill template, Stainless Steel mounting hardware for installation & manual


- A video all about the Remote Start Kit is available on YouTube.  Search "MEP 802A MEP 803A Remote Start Kit" 

Once built each Controller is tested in a generator simulator and then installed in an MEP-802A, tested and initially calibrated to assure a defect free unit.

Customer support provided to assist with installation.

Returns accepted within 30 days.


Click on "See Other Items" to see the variety of MEP Generator supplies and accessories available!