Precautions for motor:

1. When you use the motor, there should be no binding objects, such as adhesive, which should not be injected into the bearing through the rotary bearing, to hinder the operation of the motor.

2. The rotation of the shaft may have the opposite effect on the life of the motor. In order to prolong the service life, please check whether your load products are in accordance with the regulations, and do not overload or hang objects at the shaft end that will hinder the rotation.

3. The eccentric heavy radiation load is produced, which is harmful to the life of the motor.

4. Do not store it in high temperature or extreme humidity around or in corrosive gas, which will reduce the effect of the motor.

5. Do not operate the motor in high temperature and humidity.

6. When soldering is required on the motor terminals of the positive and negative poles of the power supply, the temperature of the soldering iron is 340 ℃± 40 ℃, and the heating time is less than 3 seconds. Do not deform the plastic. During the operation, let the soldering point flow into the motor or break the end of the wire, which will cause the motor function to decline.

7. Do not let the motor shaft get stuck. When power is supplied, the motor will overheat and burn its accessories in a short time.

8. Due to the lack of skills of the staff, the quality of the motor cannot be guaranteed in case of the matters mentioned in the manual, or the apparent fault.

9. Supply the specified power and make sure it is within the measurable requirements.

10. The pulley or gear shall be installed without abnormal weight during pressing.

11. When installing the motor, if the screw is too long, it will cause contact between the motor itself and the rotor, which will affect the characteristics.