eBay

QTY: 1pcs 2 Channel receiver contrller and 1 pcs 2 button handsender . (This remote doesnot have a battery inside )

Receiver :

Technical indicators:

Working voltage: AC220V;

Operating frequency: 433.92MHz;

Receiver sensitivity:-95dB;
Encoding: Receiver Recording;
Momentary / Latch / Toggle selectable (defult is Momentary , Latch Mode need 2 buttons handsender );
Output mode : Relay switch or AC220V power switch (Relay switch is defult ) ;
Receiver size: 62 * 35 * 22 mm;

Max load : 500W;

2 Channel;

Advantage :

1: Receiver Mother board have a learning key , if the remote is lost , must buy EV1527 or PT2262 remotes to re-learn;

Work mode (programmable )

singnal Inter-locking (Latch)
singnal Self-locking (Toggle)
singnal Non-locking (Momentary is defult )

Momentary------------Press the Transmitter button A, the receiver relay A is ON, release button A; the receiver relay A is OFF, the same as B/C/D ,Every channel is Independent ;

Toggle---------------Press transmitter button A for 1 time , the receiver relay A is ON, press button A again, the receiver relay A is OFF, the same as B/C/D. Every channel is Independent ;

Latched------------------

Press transmitter button A, the receiver relay A is ON, the relay B/C/D is OFF.

Press transmitter button B, the receiver relay B is ON, the relay A/C/D is OFF.

Press transmitter button C, the receiver relay C is ON, the relay A/B/D is OFF

Press transmitter button D, the receiver relay D is ON, the relay A/B/C is OFF.

User guide instruction :

1:Clear the deposit information

Keep pressing learnig key on receiver controller board , LED turn on after 2 seconds , then turn off after 4 seconds , it means clearing successfully . ( our remote is already programmed before dispatch , please don't clearing ).

2: Relay working mode selecting :

1: keep pressing learning key on the receiver controller ,

LED turn on after 2 second , then turn off after 4 second, then the receiver controller enter programming state , but not release the finger , still keep pressing the learning button ,

LED blink once after 2 second , release the finger on learing key , it is Momentary mode ,

or still keep pressing learing key ,

LED blink twice after 2 second , release the finger on learing key , it is Toggle mode ,

or still keep pressing learing key ,

LED blink 3 times after 2 second , release the finger on learing key , it is Latch mode ,

3: Learning the remote to the receiver controller:

A: Keep pressing learnig key on receiver controller board , LED turn on after 2 seconds , release the finger on learning key , press " A" buttons on the remote work state LED blink 3 times , it means "A" buttons was memoried by Channel 1 .

B: repeat step A to memoried "B" button by Channel 2 .

light connection :

motor connection :

Transmitter Remote :

Technical Data :

Transmitter Module No.: YK004 -2 2 Chanels

Power supply : 12V 27A battery replacable .(This remote doesnot have a battery , Please buy in on local market )

Operating current: ≤ 12mA;

Oscillation mode: SAW resonator;

Modulation mode:ASK;

Operating frequency:433.92MHZ ;

Frequency deviation:±0.2MHz;

Encoding format: Learning Code ( EV1527 ) . Cannot cloning or copy any remotes ;

Transmit power:10 mW.

Data Rate : 50~60KHZ;