Lemon RX LM0086VP DSMP 7ch RX Telemetry, Stabilizer, Voltage Probe Receiver

Lemon RX LM0086VP DSMP 7ch RX Telemetry, Stabilizer, Voltage Probe Receiver


Description

Product Specifications
 
Dimension: 55mm x 15mm x 23mm
Recommended voltage range: 3.9V to 8.5V (2S LiPo capable)
Telemetry Option: Integrated with Barometer, Altimeter, Energy meter (Require V/I sensor) and Internal Temperature Sensor
Technology: DSMP with GEN2 SDR stack (DSMX / DSM2 compatibility)
 
The generation 2 DSMP 7-channel telemetry stabilizer is a complete redesign that provides the ultimate reliability, features and performance.
- DSMX / DSM2 compatible, 7-channel full-range telemetry stabilizer with full telemetry features including a built-in barometer, altimeter, energy meter (Current, Voltage, mAh),  and internal temperature sensor
- High sensitivity gyro with proprietary stabilization algorithm ensures responsive airplane control for both electric and gasoline engine application
- BEC1 and BEC2 dual inputs allow high-reliability operation while improving setup for high current drain performance servo
- Built-in Delta, V-tail and Normal Wing mixer
- Supports stabilization with separated channel dual aileron operation
- Stabilization always-on feature
- Real-time variable stabilization gain control on channel 8
- All-channel failsafe
- Firmware health monitoring software stack and ultra-low operational voltage (3.6V) ensure the highest hardware reliability
- Generation 2 SDR stack ensures the fastest channel searching and advanced algorithm for signal recovery with ultra-low-latency experience
- Antenna diversity improves the reliability of the wireless link 
- Satellite port for additional signal diversity
- Gyro stabilization activation with either AUX2 or Gear channel
- 3 potentiometers for individual gain tuning
User manual
- See www.lemon-rx.com/manual

Quick Reference Guide
Reset stabilizer
- Connect power
- Hold F and B buttons (approximately 5 secs+) until all LED flashes randomly
- Press the C button. Multiple LEDs flash a few times to complete the operation
Bind with bind plug
- Insert bind plug on Channel 7
- Connect power
Bind without bind plug
- Connect power
- Hold the B button until the red LED flashes
 
Bind with a satellite without a bind plug
- Connect power
- Hold the B button until the red LED flashes
- Disconnect power
- Plug the satellite wire connector into the stabilizer
- Connect power
Failsafe
- Connect power to the receiver and ensure the servos are working with the transmitter
- Press the F button for 3 seconds until green changes from off to on and vice versa to change the failsafe setting. Channel value is saved as failsafe default at the time the green LED turns on. 
- Turn off the transmitter and wait 2 seconds to ensure the failsafe is activated accordingly by ensuring there is torque generated with finger-pushing the servo linkage if it was to be set. Vice versa.
Stabilization activation switch
- Disconnect power
- Insert bind plug to channel 5
- Hold the C button
- Connect power. Wait for about 1 second until the 6 LEDs flash.
- Release the C button
- Press C to make changes within 3 seconds. Green = CH7, Blue = CH5.
- Wait for 3 seconds and remove the bind plug
Wing Mode and Dual Aileron
- Disconnect power
- Insert bind plug to channel 6
- Hold the C button
- Connect power. Wait for about 1 second until the 6 LEDs flash
- Check the receiver label/user manual to understand the referred LEDs' operation 
- Release the C button
- Observe which red LED is flashing and brief press C to select the required mode
- Press C to toggle between settings. On means selected. Exit automatically in 5 seconds.
- Wait for 3 seconds and remove the bind plug
- Ensure transmitter mixing is set accordingly for dual aileron if stabilized dual aileron is to be configured.
Gyro direction
- Check the receiver  label/user manual to understand the referred LEDs' operation
- Connect power and wait 1 second 
- Hold the C button and wait for about 1 second until the 6 LEDs flash
- Release the C button
- Observe which red LED is flashing and brief press C to select the required mode
- Press C to toggle between settings. On means selected. Exit automatically in 5 seconds.
- Wait for 3 seconds and remove the bind plug.
V/I sensor calibration
- Turn on the receiver and transmitter. The telemetry report page may optionally be checked during and after calibration.
- Plug the V/I sensor. Make sure the required DC loading device such as a brushless motor with ESC as well as the current and voltage meter is connected. 
- Press the F and B buttons together at the same time for 2 seconds but no greater than 5 seconds
- Observe 3 green LED flashes. Ensure 8.4V is provided to the V/I sensor.
- Press F or C button briefly
- Observe 3 red LED flashes
- Turn on the DC loading device by throttling the transmitter. Ensure 4A is drawing across the V/I sensor. Be careful with the motor spinning if it is to be uséd.
- Press the B button to save and exit.
V/I probe calibration
- Turn on the receiver and transmitter. The telemetry report page may optionally be checked during and after calibration.
- Plug the V/I sensor. Make sure the required DC loading device such as a brushless motor with ESC as well as the current and voltage meter is connected. 
- Press the F and B buttons together at the same time for 2 seconds but no greater than 5 seconds
- Observe 3 green LED flashes. Ensure 8.4V is provided to the V/I sensor.
- Press F or C button briefly
- Observe 3 red LED flashes
- Press the B button to save and exit.
Gain setting
- Adjust via the 3 dials or real-time master gain on channel 8 depending on the transmitter channel's availability.
 
View setting LEDs with all on
- Press the C button briefly (no more than 2 seconds).
Lemon Rx products are tested to be compatible with Spektrum's DSMX and or DSM2 product (Spektrum, DSMX and DSM2 are the registered trademark of Horizon Hobby, Inc.).

  • Shipping Policy
    • All orders are shipped within 24 hours during regular business days. We ship Monday-Friday and on some Saturdays as well. If you have any questions about shipping please contact us first.
    • Many of our items come with free shipping. If you are purchasing multiple items on which shipping is charged, please follow one of the following two methods for the best shipping rate:
         - Option 1: Add the items to your cart, and then from your cart, hit the Request Total From Seller link and then wait for us to send you an invoice with adjusted shipping.
         - Option 2: Use the Buy It Now option and NOT the "Add to Cart" option, then select Commit To Buy for each item and wait for us to send you an adjusted invoice.
    • Ebay CANNOT combine shipping automatically, so please wait for our combined invoice. We send out invoices throughout the day. If you do not wait for a combined invoice then WE CANNOT REFUND THE EXTRA SHIPPING.
    • We ship INTERNATIONAL, all rates are calculated automatically through Ebay. You will see your shipping price displayed for the country in which you are having the item shipped to.
    • Most Domestic Shipping is via USPS First Class Package or Priority Mail. Some heavier items may be shipped via FedEx.
    • Most International Shipping is via USPS First Class International, heavier packages may go via USPS Priority.
    • We ship to Alaska, Hawaii, Guam, US Virgin Islands, APO/FPO and Puerto Rico.
  • Payment Methods
    • Paypal is the only method of payment we accept. Any payments made via E-Check through Paypal must clear before item is shipped.
    • Notes left at checkout or on your Paypal payment may not be noticed, if you have any comments please be sure to send us a message directly to ensure we see your comments.
    • We ship fast so if you have a request to change your order please contact us ASAP.
    • SALES TAX will be charged on all orders shipping to California.
  • Return Policy
    • We accept returns on UNUSÉD and UNOPENED items within 14 days of purchase.  Any item that has been opened or uséd cannot be returned unless it is defective.
    • Please contact us first before sending any item back for return instructions.
  • Feedback
    • We leave positive feedback to all buyers who complete a purchase and we strive to earn positive feedback and 5-star ratings in all categories.
    • If you have a problem with an item you receive, PLEASE CONTACT US FIRST before leaving negative feedback to resolve the issue.

Store Home | View All Listings |


Copyright © 2023 RCJuice. All rights reserved.

 RCJuice eBay Store

eBay integration by