New 10 Pack Quartz Clock Movements Mechanisms Motors Metal Hands Clock Making
REPLACEMENT MOVEMENT EASY ORDER SYSTEM
1 - Remove your old movement (Black box)
2 - Measure the spindle length (protruding
Gold & plastic piece) and match to the chart below
MOVEMENT TYPE |
SILVER THREAD LENGTH |
TOTAL SHAFT LENGTH |
SHAFT WIDTH |
Short – For clock faces up to 3mm thick |
6.7mm |
14mm |
7.6mm |
Medium – For clock faces up to 9mm thick |
11.7mm |
19.5mm |
7.6mm |
Long – For clock faces up to 12mm thick |
15mm |
22mm |
7.6mm |
Extra-long – For clock faces up to 16mm thick |
20mm |
28mm |
7.6mm |
Supersize – For clock faces up to 22mm thick |
24mm |
32mm |
7.6mm |
3 – Decide on ticking or non-ticking
4 – Fill in your information in the drop-down box’s above
5 - Hangers can be removed on request
6 – Add the quantity required
7 – Then simply buy it now or add to basket to continue
- 10 Movements and 10 sets of hands available in 5 spindle sizes -
Short, medium, long, Ex long & Supersize
- Ticking - Standard ticking
- Non ticking - Second hand sweeps rather than ticks for a quieter
movement (not silent)
- Movement dimensions - height 70mm (55mm with hanger removed) -
width 55mm - depth 16mm
- Press fit metal hands in sizes 24mm - 130mm (Please select above).
- Hand measurement shown is taken from the centre of the minute hand
hole to the tip of the minute hand
- Hands come with a removable protective seal
- Complete with all fixings
- The movement brand and shaft colour can change from the photo's
attached and although the silver thread and OK888 movement is used with
most orders this may change on some occasions but a compatible model will
still be sent
- Mixed combinations available, please contact us with any
requirements
- ROHS approved
- Hangers can be removed on request (this will leave a small scratch
to the top of the movement)
- Fully tested
- Fitting instructions included