* This Listing is for 2 Supports which fit the Following Applications :

1989-1994 Geo Metro Base Hatchback 3-Door Hatch (L-R)

1989 Geo Metro LSi Hatchback 3-Door Hatch (L-R)

1991-1994 Geo Metro LSi Hatchback 3-Door Hatch (L-R)

1989-1994 Geo Metro LSi Hatchback 5-Door Hatch (L-R)

1989-1994 Geo Swift Base Hatchback 3-Door Hatch (L-R)

1990-1992 Holden Barina MF 3-Door Hatch

1990-1992 Holden Barina MF 5-Door Hatch

1990-1992 Holden Barina MH 3-Door Hatch

1990-1992 Holden Barina MH 5-Door Hatch

1990-1994 Pontiac Firefly Base Hatchback 3-Door Hatch (L-R)

1989-1994 Suzuki Swift Base Hatchback 3-Door Hatch (L-R)

1989-1994 Suzuki Swift GA Hatchback 3-Door Hatch (L-R)

1989-1994 Suzuki Swift GL Hatchback 3-Door Hatch (L-R)

1989-1994 Suzuki Swift GLX Hatchback 3-Door Hatch (L-R)

1989-1994 Suzuki Swift GT Hatchback 3-Door Hatch (L-R)

1989-1994 Suzuki Swift S Hatchback 5-Door Hatch (L-R)

Extended Length: 24.17 Inches

Compressed Length: 14.67 Inches

*How to Install :

*Installation Requirements:

1. Use Safety stands whenever a procedure requires you under the vehicle or supports. Or have someone hold the lid open for you so that they can raise or lower it as needed.

2. Before removing the old lift support, inspect the end connections and compare them to the units on your vehicle to make sure that they are the same As well as the extended length.

3. Lift Supports need to be installed fully extended. In most cases you just can't compress them unless they are on the vehicle. Never force a support.

4. If the ends are not lining up the support may need to be turned. To do this attach the shaft end of the support to the vehicle and then turn the entire body of the support clockwise unit the ends line up.

5.Once installed, check for looseness. If you have any problems during the installation PLEASE contact us.