This is a replacement set of 3 black buttons for the Snowman from General Foam and Empire. You will receive 3 medium buttons per purchase. This fits most of the 34 and 40 inch snowman blow molds. I have included a picture of one of the snowman versions that this fits. Our button is the top one on the chest area. As you can see it works quite nicely as a replacement.
This is a 3d printed design created and printed by our family.
The second picture shows an original button beside the 3d printed button. You will not receive the original button. It is only shown for comparison.
These prints are quite small, thin and delicate, please read instructions below as to not force them in the blow mold so we don’t break buttons or blow molds.
We size as accurately as possible to the original part with pin type push thru parts making several sets until we are happy with the results, but your blow mold holes may be slightly smaller or larger due to difference in wear. You may need to add a small amount of glue to hold in place or you can sand part or use a very small drill bit to drill a tiny bit of the hole to make fit if too tight (do not force as we can’t damage our vintage blow mold or break buttons).
Dish is not included, only used to photograph.