Operation steps The step of Reel the steel wire
1. Turn the switch to "=" place
2. Turn the shift switch to manual position,Turn on the emergency stop switch
3. Turn off the motor switch, adjust the speed to the lowest place
4. Fix one side of steel wire on the one side of the roller,reel one or more,then pass by the wire wheel
5. Turn on the power switch,Turn on the motor switch,adjust the suited speed slowly
6. Begin to reel the steel wire,When the steel wire on the roller is enough,turn off the motor switch
7. Reel the rest steel wire to another wire wheel,then fix the roller groove by pliers
8. Turn on the motor switch , Set the motor speeder to the half of the position .
(steel wire circle direction must follow around the first wheel in the opposite direction)
9. Turn the direction switch to the opposite direction
10. Ensure the direction is all right,turn on the motor switch,adjust the speed slowly
11. The quantity of both roller are almost the same,turn off the motor switch,The step of Reel steel
wire is finished
The step of Screen separation
1.time is set to 01S01S, a temperature of 80 degrees
2.Put the silica gel on the heated plate holes to holes
3.Put downwards the screen onto the sillica gel,Adjust steel wire to the height of pressing the glass exactly
4.Turn the shift switch to the automatic position.
5.Turn on the motor switch,push the heated plate.The screen separaton has begun.
6.Until the LCD separtes from the glass,turn off the motor switch and power switch,the step of screen separating is done.
