DC12-24V Mobile Phone NFC Control Board Fingerprint IC Card DIY Relay Module 13.56mhz Access Control Proximity Card Controller
Features:
Jog/self-locking/ignition three control modes.
Jog mode can adjust 10 kinds of time delay:300ms/600ms/1S/2S/3S/4S/5S/10S/60S/15 minutes.
Support fingerprint, IC card, mobile phone NFC three identification verification methods and can be connected to the button switch.
Applicable to scenarios such as building access control, jewelry display cabinets, vehicle modification, and access control of various cabinets.
Specification:
Compatible with DC12V-24V voltage range;
Three verification methods: fingerprint, IC card, mobile phone NFC
Three control modes can be switched: jog mode, self-locking mode, ignition mode;
In the jog mode, the output time can be adjusted, and the output can be up to 15 minutes;
With relay normally open and normally closed output control.
IC card/NFC sensing distance: ≥25mm
Can be connected to the exit button
Three control modes:
Inching mode: turn on after fingerprint recognition; automatically turn off after releasing the finger and reaching the set delay time.
Self-locking mode: turn on after recognizing the fingerprint; after releasing the finger, it will be disconnected immediately after re-identifying the fingerprint.
Ignition mode: keep the fingerprint recognition unreleased; it will keep on all the time, and it will disconnect immediately after releasing the finger
Note:
1. Due to the light and screen difference, the item's color may be slightly different from the pictures.
2. Please allow 1-3cm differences due to manual measurement.
Package Included:
1Set x NFC control board fingerprint IC card DIY relay Kit