Love your Buell, but got floppy turn signals?
These 3D Printed brackets provide a tight and strong brace to prop the turn signal back to near OEM leveling.
No Disassembly.
No Rewiring.
Easy 5 minute install for all 4 corners.
Made on a high precision resin 3D printer with tough, durable, and better than ABS strength.
*There are 3 sections that typically break between the ribs of the turn signal rubber. It doesn't matter which section failed, the brackets apply to all 3 break locations.
What's included:
(8) Turn Signal Bracing Brackets. (3D Printed)
- Two are required per light.
- This is enough to do all 4 of your lights.
- There are 4 in a bag with "O" designed into them.
The "O" brackets are longer and for the front lights.
The "O" goes on the outer side of the bike. i.e. away from the rider.
(8) Durable, high strength, Zip-Ties. (Injection Molded)
- Two are required per light.
- This is enough to do all 4 of your lights.
1) Install by lifting your turn signal to original location.
2) Align the bracket ribs with the turn signal sections.
- Flat sections go Top/Bottom
- Sections with the ribs face front/back
3) Squeeze both brackets around the turn signal and press the ribs into their locations.
4) Put zip ties around the bracket and tighten.
- The Zip Tie should fit in between the vertical ribs, and there's corner reliefs to properly locate.
- Be sure to clock the zip tie block where you want it.
5) Re-squeeze the brackets and tighten zip ties again to ensure a snug fit.
- The corners of the bracket should align up with the designed locating slots for the zip ties.
6) Clip off excess zip tie as needed.
7) Ride On and Keep the rubber side down!!!
My '06 XB12Ss is shown, but not included.
*****Please review the pictures for the style of turn signals these go on before ordering.*****
Fits Reference P/Ns:
Y0526.K
Y0527.K