1993 YAMAHA YZ 80 Yamaha OEM Style Graphics.

To suit YZ 80 two stroke from 1993 - 2001, however this kit is designed as per the 1993 model graphics. 

Designed to fit standard YZ plastics from '93-'01, and does will not fit any restyle plastics kits.  

We can change the race number on the backgrounds and can also change sponsor logos on the rear fender at your request. 

Background and number colour can be changed to suit your preference.

Please leave a message if you would like to make minor changes to this kit and we will do our best to accommodate.

Payment to be made before graphics kit is printed.

Please allow 35 business days for processing, printing & postage.

Please note: Not all reproduction plastics are the same dimensions, nor are graphic templates, and as such some graphic templates may require trimming for best fit to your plastics. The tank decal for this kit is not perforated.

GRAPHICS INSTALLATION INSTRUCTIONS

PREPARING THE PLASTICS FOR INSTALLATION

  2. Before you can properly install your new graphics to plastics you would need to properly prepare your plastics surface.  
  3. If your plastics have old graphics, they will need to be removed. Heating up old graphics with a heat gun or blow drying will help to losing the old adhesive.
  4. All surfaces, especially brand-new plastics, need to be wiped and cleaned using an appropriate adhesive removing solvent. Using methylated spirits or a contact cleaner will work well for this.
  1. *Please note that heat can be used to help apply graphics. Applying heat will help graphics bend and conform to complex plastic shapes. However, use heat sparingly. Graphics material reacts to very little heat, so over heating will make adhesive possibly fail and distort graphics in conjunction with installation.If possible, it is recommended that you remove plastics from bike before installing graphics.

    GRAPHIC INSTALLATION

    1. Correctly identify the graphic part with the corresponding plastic piece.  The graphic should be a similar shape to the plastic.
    2. After the graphic is line up with the plastic. Begin by peeling of a corner of the backing paper of graphics and stick that part to the plastic.
    3. Gradually remove more of the backing paper and stick more of graphics to plastic. If graphic is becoming miss aligned, peel back graphic off plastics and realign.
    4. Repeat step 3 if graphic is starting to ripple or not properly confirm to complex plastic shapes.
    5. After graphics are completely installed on all plastics, lightly apply a little heat to parts to help adhesive set up.
    6. To get the longest life out of your graphics it is highly recommend that you wait 48 hours after installation to let the adhesive set up.