We here at F3D have designed this Custom 3d printed Card 12 DOUBLE MAG holder that attaches to your Umarex Notos Picatinny rail!
When you need a loaded mag, just push with your thumb and grab the mag, Mag will pop right out!
*Mags are held in place with tight tolerances, in order to pull out, use thumb to push under mag-
mag will pop out, just grab it!
These are Custom Printed by F3D Printing!
" This WILL ONLY HOLD 12 SHOT CARM MAGS - revisions are underway to hold aftermarket smaller mags"
MAG holder bolts onto your existing picatinny rail!
You can add this MAG holder under the front of your scope or anywhere you have extra space so you don't loose your pricey and hard to find mags!
These install in minutes! You can even add multiple to the Picatinny rail!
INSTALLATION INSTRUCTIONS:
1. Pull out the included bolt & nut( stainless steel included)
We like the way the mags are held when F3D Notos faces the user -
2. Slide from either the mag loading area or the front of the rail and place your
DOUBLE MAG holder onto your pica-tinny rail.
3. Add the bolt and nut (make sure nut is placed into its correct location , you may need to hold with finger)
then tighten it snug!
We like to load our mags with the words CARM out - so you can see if its loaded with pellets
Please note : Mags only properly fit 1 way
- please note and look at mag holder and sample photo in our PHOTOS-
Mag holder has writing to show side to insert mag with arrows
Mag must be inserted HEAD FIRST into holder in order to CLICK -
Once Mag CLICKs- that's it. Its locked into place.
(Mag has space to move around a little bit - this is NORMAL - )
Mag will NOT release unless you Pop it out with your fingers!
To release: CARM 12- shot Mag -
Push with your thumb on the back side of the mag Holder (says BACK) see PHOTOS -
Push the Head of the Mag- mag will pop out - grab the mag.
This holder WILL NOT WORK WITH STOCK MAGS!!!
ONLY (1) ONE ---- Double 12 SHOT CARM MAG holder is included in this listing, color of your choice!