Description:

Model:36GP-BLDC3525 Miniature DC Permanent Magnet Brushless Geared Motor
Shaft diameter:Output shaft diameter 8mm D-shape
Voltage:Maximum power 8W at 24V
Voltage range:10V~30V
Dimensions:Diameter 36mm Length 52~76mm (without shaft)
No load current:150mA
Product Details:
1. Adopting all-metal gear material makes it more wear-resistant and prolongs its service life.
2. Steel ball bearings, low friction resistance, low noise, long life, fast heat dissipation, high precision, strong composite ability.
3.D-type shaft, more convenient to install, not easy to slip, saving installation time.
4. Built-in inductive Hall drive board, directly energized to run without external drive circuit.

Wiring mode:
Red wire: connect the positive pole of the power supply
Black line: connected to the negative pole of the power supply
White wire: vacant
White and black wires: in parallel with the negative terminal (change the original steering)
Blue wire:PWM speed control line, connect to 0-5V pulse width governor
Yellow wire:FG signal line output hall signal, base pulse a circle of 9 signals

Note for forward and reverse rotation adjustment:
Brushless motor supports forward and reverse rotation, but due to the built-in driver board chip is more sensitive to the current it is recommended that when adjusting the steering, do not take the instantaneous adjustment, you can take the following two ways to adjust to ensure long-term service life
1- Disconnect the power supply when you need to switch the steering, and switch the steering again after about 2~3 seconds; 2- Adjust the rotational speed by PWM.
2. Adjust the rotational speed to a lower speed through PWM control, and then switch the steering through the white wiring.

Package Inckuded:

According to your choice.