How to use your Laser Monkey
Step 1: Remove screws from the top of the Laser Monkey using Allen key provided.
Step 2: Ensure laser is pointing at the floor. Place the two batteries provided in the space behind the laser. Negative terminal of batteries to connect with laser spring.
Step 3: Position head back onto body ensuring switch terminal fits behind both batteries. Screw the three screws back into head to secure in place.
Step 4: Widen the arms on the Laser Monkey outwards by twisting the adjuster to allow enough space to fit over your chain or belt.
Step 5: Pass the Laser Monkey over the chain/belt and adjust the arms inwards until they grip a flat part of the rear sprocket/pulley. Ensure the Laser Monkey is gripping to clean, dirt free, flat parallel surfaces.
Step 6: Point the laser down to the closest part of the chain/belt and turn on. The laser should appear in the centre of the chain link or belt. If not centralised initially, adjust positioning to centralise the laser.
Step 7: Lift the laser head to point at the furthest visible point of the chain/belt towards the engine. Adjust the wheel alignment until the laser is showing at the centre point of the chain/belt. Your wheel will then be accurately aligned.
Step 8: Lock the rear axle nuts and adjustment nuts, turn off the laser and remove the Laser Monkey from your sprocket or pulley.