Specification:
Product Type: Mass Airflow Sensor (MAF Sensor)
Condition: 100% Brand New
Color: As picture showed
Material: Plastic
Package:1pcs MAF Sensor
Fittment:
please check the compatibility of your car before purchasing.
Note:
Please check and confirm the compatibility before purchasing
Connect us:
Any question or problem, please feel free to contact us.
How to Replace a Mass Airflow Sensor?
Materials Needed
?Gloves
?Replacement mass airflow sensor
?Screwdriver
?Wrench
Step 1: Disconnect the electrical connector from the mass air flow sensor.
Squeeze the tab on the harness side of the electrical connector while firmly pulling on the connector.Keep in mind, the older the vehicle, the more stubborn these connectors can be.
Remember, do not pull on the wires, only the connector itself. It helps to use gloves with a rubberized coating if your hands are slipping off the connector.
Step 2: Disconnect the mass air flow sensor.
Use a screwdriver to loosen the clamp or screws on each side of the MAF that secure it to the intake pipe and air filter. Once the clamps are removed, you should be able to pull the MAF right out.
Step 3: Connect the new mass airflow sensor.
The sensor slides into the intake and then is clamped on.On the airbox side, it may reconnect with bolts or it may be the same as the intake side, depending on your particular vehicle.Make sure all the clamps and screws are snug, but do not overtighten them as the sensor is plastic and can break if handled too roughly.
Step 4: Reconnect the electrical connector.
Reconnect the electrical connector to the new mass airflow sensor by sliding the female side of the connector over the male side that is attached to the sensor. Press firmly until you hear a click that indicates the connector is seated all the way and locked into position.
At this point, double check all your work to make sure you haven’t left anything loose and the job is complete.
Warranty: 1 year