Origin: Mainland China Type: Sync Motherboard Cable Model Number: Flexible Strip Light Package: Yes Band: COOLMOON AOSOR Model: AL200 Material: Silicone Lamp bead: 56pcs Light bar: 4 Voltage: 5V DC Current: ≤ 0.7A ± 10% Power: ≤ 3.5W ± 10% Interface: 5V 3PIN * 2+4PIN (5V 3-pin female - plug into the motherboard 5V ARGB Aura Sync interface, 5V 3-pin male - connect with other 5V ARGB products in series to light up the light; insulation protection cap - pin interface is not used, Cover the cap to prevent short circuit; small 4PIN interface - dedicated interface for COOLMOON brand controller (when the motherboard does not support 5V ARGB, you can purchase the Coolmoon controller to use with it) Wire length: 650+10% mm Light plate: 200x59x12mm/7.87x2.32x0.47in Total weight: 0.23kg (including package) Installation method: (1): Tie fixing The AL200 flexible light board can be installed on the graphics card and the power supply line of the motherboard by fixing it with a tie. Installation method: A. Insert the cable tie from a hole on the back of the transparent buckle, B. Pass the cable tie through another hole, fasten the cable tie to the graphics card and the power supply cable of the motherboard, then tighten the cable tie and cut it off the excess (2): Double-sided tape fixed By fixing with double-sided tape, the AL200 flexible light board can be pasted on the free plane of the chassis for use. Installation method: A. Paste the double-sided tape on the transparent buckle, B. Tear off the protective film on the surface of the double-sided tape, and then paste and fix the AL200 soft light board to a suitable position on the chassis. Note: Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you! Please allow 1-2cm measuring deviation due to manual measurement.