Astronomical Telescope Universal Edition Main Mirror Aluminum Box Suitable for 5-inch, 6-inch, 7-inch, 8-inch
(length, width, height 650 * 300 * 455mm)
Customers need to DIY themselves to dig trenches, which can not only install the main mirror, but also accessories such as eyeglasses
Suitable for:
Star Trent C6, C8, C8HD,
5SE, 6SE, 8SE, (with bent arm)
127SLT (with bent arm)
5SE Evolution, 6SE Evolution, 8SE Evolution,
Xinda Maka 127, 150, etc
Jinghua Maka 127, 150, etc
Bo Guan 130190015018002002400
Equatorial instruments EQ3D, HEQ5, EQ6-R, CG4, AVX
EM60 EM100 EM11
EXOS-1 EXOS-2 equatorial instrument, etc
Once the shockproof filler inside the box is excavated, it will not be returned or replaced.
Received goods:
1: First, check the box for damage, cracking, and quality issues - if there are any issues, you can contact customer service online for replacement. Or refuse.
2: Measure the length, thickness, and width of your mirror to see if it can fit (especially pay attention to thickness) - if it cannot fit, you can still contact customer service for a return at this time.
After entering the third step below, returns and exchanges will no longer be granted:
3: After the first two steps of inspection and confirmation, draw a line on the shockproof cotton inside the box. The front end of the main mirror is kept at a distance of about 2-3cm from the box board, and the tail end is also kept at a distance of about 2-3cm from the box board. Position yourself on the left and right sides, but not less than 2-3cm away from the side. The other side can be dug with slots for other accessories;
4: When designing the position of the main mirror, it is important to consider the position of the center of gravity, as much as possible in the middle, otherwise the weight will be on one side and you may feel uncomfortable when carrying a box.
5: Following the line, use a sharp art knife or blade to gently cut along the line, preferably with a straight edge. The cut is neat and aesthetically pleasing.
6: When excavating the groove, pay attention to the depth, do not scratch the bottom plate, and maintain a distance of 2-3cm from the bottom plate.
7: Take out the excavated protective part, put the main mirror accessories in, and complete.