These are NOS parts from the late 90's, Made in Japan. Dual 50K Ohm (50K Ohm BX2) as original with loudness tap. The solder terminals are different than the original, but are not a problem to install in the Marantz receiver.
Note: These NOS parts originally had a 20MM shaft length, this is too short for the Marantz receiver. Therefore, I modified the shaft to 25MM to properly fit these Marantz receivers.
Also: the loudness tap is located at 20K Ohm, the original pot was 15K OHM. (Most original that I have measured was actually at 11K to 12.5K Ohms). I have installed these Modified NOS pots into several Marantz receivers, they worked perfectly.
However, I did notice that the loudness setting with the 20K Ohm Tap increased the Bass boost on some receivers.
I will install a 51K Ohm in parallel with the 20K tap, this equals 14.3K Ohms for the loudness Tap. You may remove the 51K Ohm resistors if you want more loudness boost.
I guarantee these to work as described or money back.
Model Original part number
2325 |
RM0503061 |
2330 |
RM0503061 |
| |
| |
I am a Marantz collector/restorer and I have installed these Modified NOS pots into several Marantz receivers, they worked perfectly.
I can also fix most broken or bent shafts using this modification process. Let me know if want a potentiometer repaired.