Collecting listings has surprises
Description The board can use the same firmware as Ramps1. Relative to the Ramps1. Its five motor outputs are powered by A4982 stepper drivers. BASE is suitable for 3D printer manufacturers on batch production, and being used as main board. BASE is designed to be flexible in the user's power source availability, allowing any power supply from 12V-24V. It features an onboard AT.
BASE is a feature rich electronics solution for Reprap and other CNC devices.
.4.4, it adds heating output
Features
- 3x temperature ADC connectors for thermistors
- + SD-CARD connector,RepRapDiscount SmartController compatible pin header on board
- fuse for short-circuit protection.
- Warm Tip: Dear buyer, Due to lighting effect,monitor's brightness,manual measurement and etc, there could be some slight differences in the color and size between the photo and the actual item. sincerely hope that you can understand! Thank you!
- Firmware can use the same configuration as ramps1.4
- 4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed,Extruder0,Extruder1, Fans)
- MEGA compatible At and FT232 processors are compatible with all RAMPS class firmware
- Easy connect TFT on AUX-1
- Up to 5 motor driver with A4982
- 4 layers PCB, optimize heat dissipation.
- Color: As shown
- Material: Plastic and metal
- Size: 11x9x2cm