The price include:

- Electric heating film Excel 220V,  warranty - 10 years;

- Sealing and isolating tape Sika-Multiseal serve for insulating and fixing electric circuit connections and contacts - piece of tape;

- instruction.

!Attention:

- heating film with width 50cm is 110W/m;

- heating film with width 80cm is 112W/m;

- heating film with widht 30cm is 65W/m.

Wires not included!

Experience with these heating films already 15 years!

There have been no defects during 15 years!!!

e-floor.eu

If you buy more than 1m, you'll get a discount, but if you buy a roll of thermal film (100 m), you'll have a great discount!

This film is made in South Korea.

Technical Data:

- Voltage: 220V

- maximum power: 110W/m (with width 50cm), 112W/m (with width 80cm) or 65W/m (with width 30cm).

- Width: 30cm, 50cm or 80cm

- Cutting step: every 25cm

- Thickness: 0.338mm

- Warm-up temperature: ~ 40°-41° C degrees heating film with width 80cm and ~ 46°-48° C degrees heating film with width 50cm or 30cm

- Guarantee: 10 years

We offer HEATING FILM with 140W/m2, 220W/m2, 440W/m2, THERMOSTATS and PEPI REFLEKT POLY material, to find out the price - please, write.

Delivery time to Europe countries ~ 7-22 working days;

Delivery time to other countries ~ 15-40 working days.

Heating foil which protects bathroom mirror anti-fog.

Switching on and off can be used in several ways, most often it is connected to the mirror lighting - thus, turns on and off along with the lighting.

Installation of heating film under a mirror:

 - Make sure that the rear surface of the mirror is clean and dry.

 - Lay heating film sheets according to prepared layout. It doesn’t matter which size up, because heating film heats equivalent to the both sides.

 - we recommend to solder wires to copper strip by using temperature-resistant solder. Connection places must be carefully insulated with unvulcanized rubber or bitumen insulation tape (Sika MultiSeal, etc.) In the same way other ends of copper strips must be insulated, where wires are not connected. To make surface even, connection places may be submerged in reflecting material, located under heating film, cutting out respective hollows in them.

 - Lay reflecting heat insulation material (Pepi Reflekt Poli, etc.) Material can be 3–6 mm thick. To prevent displacement, material must be fixed on base surface and sheets must be fixed each to other with construction adhesive tape (Moment or other), or you can use the double-sided construction adhesive tape;

 - Attach element to the wall using reinforced adhesive tape (do not use a metallized tape).

 - The system can be connected to a lighting circuit or through a separate electric circuit breaker.