An accurate reproduction of early Clyde McCoy wahs.
Many hours of research and development have gone into perfecting the hand wound halo inductor which closely matches the specifications of original units. (I can wind to preference too if desired)
Wound with the same wire diameter the original halo inductors.
Replica Halo inductor (large hole specs)
Mullard Tropical Fish 0.22uF capacitors
Carbon Film Resistors
BC109B Transistors
Polystyrene 0.01uF capacitors
This board is fully populated and ready to solder into an enclosure.
All that is required is the potentiometer, footswitch, battery snap and wires to complete the circuit.
Demo samples (short and straight to the point):
Wah only 1:
https://drive.google.com/file/d/1402LvWGjlRzZr9BryFUqYeW8nRtloYAs/view?usp=drivesdk
Wah only 2:
https://drive.google.com/file/d/1403em5NKokuxNen-KCIKhLY9Gg9aHW73/view?usp=drivesdk
Fuzz into wah 1:
https://drive.google.com/file/d/140y9ai0Rj4DgAytcZOUa5Q3gJBOHeFq6/view?usp=drivesdk