Heavy Defender clutch pedal?

THE REVOLUTIONARY POWERspring PEDAL KIT

We have designed an affordable, cost effective pedal assist spring that reduces the weight of the pedal significantly.

As seen in the Land Rover Owners International Magazine!

THIS IS 45% STRONGER/ LIGHTER THAN THE LAND ROVER OVER-CENTRE SPRING AS FITTED TO TDCI VEHICLES

– 45% lighter than OEM “Pedal assist spring”

-80% lighter than no spring at all! (When retro fitted to TD5/ 300Tdi etc)

1. Does the POWERspring fit my DEFENDER?

The LOF POWERspring will fit Defender models 300TDI, TD5 and also TDCI PUMA vehicles.

In order to double check that it will fit, simply take a look at your clutch pedal:

• If the clutch pedal arm is a flat sheet of steel in terms of profile – IT FITS!
• If the clutch pedal arm is a U shaped formed steel profile, unfortunately it wont fit, but there is a solution! Simply remove the older 200TDI style pedal box (6 bolts in the footwell) and refit with the later style pedal box – Part number SKB500280 (sold separately)

2. How easy is the spring to fit?

*SEE FITTING INSTRUCTIONS BELOW*

5-10 minutes to fit

You will need:

• 2 pairs of mole-grips/ Pliers (ideally long nose)
• 1x medium flat headed screw driver
• 1 suitable sized pole/ something to wedge the pedal down

See our step-by-step fitting video below.

We post out the POWERspring Pedal Assist Kits by Royal Mail.

Fitting Photos:

**Disclaimer – Take care not to break the U shaped bush supplied, although this is a Genuine LR part, it is injection moulded and is easily damaged! (if you break the bush please email us and we will post one out free of charge**

Wedge the pedal down to the floor using a piece of wood/metal bar (Perfect length is 50cm)

LOF TOP TIP FOR FITTING: The lower the pedal, the easier to fit.  On the back of the pedal box in the engine bay, there is a 17mm bump stop bolt, wind this out to allow the pedal to go lower while fitting. Then once fitted, wind the bolt inwards, until the pedal stops sticking down. The spring may over power the clutch pedal if it is allowed to go to far over centre, hence winding the bolt back in stops it holding the pedal down!