Intellijel Pedal I/O 1U Effects Pedal Send/Return & High Impedance Instrument Input Module
1/4" TS jack interface for the pedal I/O 1U module
This module connects via 3 pin cable to the Intellijel Pedal I/O 1U module.
It provides the 1/4" TS interface for connecting guitar pedals or instruments.
Dimensions: 8 HP
44 mm deep
Module is a 1U tile.
Current Draw: Module does not draw current
Features
- Signals arriving at the Pedal I/O System through the RETURN jack (or from a 7U case’s IN jack if using the Pedal I/O 7U Case Adapter) pass through a Class A triode emulator, allowing for some tube-like overdrive at high gain setting
- The Pedal I/O is more than just a simple level shifter - it’s also an impedance converter, which provides proper drive and loading for any FX pedals or instruments you connect
- Separate gain controls on both the SEND and RETURN
- Use the Pedal I/O''s RETURN circuit as a ''direct box'' for connecting any instrument
- The high input impedance of the RETURN circuit allows it to be used as a piezo pickup preamp for acoustic instruments
- Use Pedal I/O in the studio as an active ''re-amping'' device to play pre-recorded tracks back through guitar amplifiers or pedals
- All inputs are protected for minimum RF interference
- Low MIX output impedance for driving long cables, lower noise, and minimum interference from outside sources