Looking to add working LEDs to your
next build? Look no further!
This listing is for traffiic advisor light bar, designed to fit in the back window area of most 1/24 models and face
out of the back window. I have designed and engineered these parts from
scratch to accomodate LEDs. This particular light bar features two random
flashing lights, one RED, two AMBER, and one BLUE. This can be installed either with the Red on drivers side, or flip it over to have the Blue on drivers side. This takes all of the hard work out of
building a model with working lights. With resistors wired in, you can hook it
up to 9V-12V and you're good to go. These are 3D printed, with LEDs built into
the part. ALL wiring is done BY HAND so some things may vary, such as exact
wire length, color, etc. but all are guaranteed to add tremendous realism to
your next model.
See my other listings for more parts to
complete your build! More pre-wired parts are available, as well as LED-Ready
(you install LEDs) and non-lit items.
*PLEASE READ*
This listing is for a Pre-Wired part
that includes working LED Lights. All lights are built into the part. They
cannot be removed or altered without destroying the piece. All lights have been
wired with resistors included to operate between 9-12V. It is suggested that
you do NOT cut any wiring past the heat shrink connection closest to the end of
the wire leads, as this is where the resistor(s) would be. Depending on your
application, you may need to add additional wire in order to install. I do my
best to include ample wiring to install the part and wire it into a power
source but in some instances you may need to add additional length to the
leads. This is a BUILDERS GRADE part. You WILL have to
disassemble your model to install, and complete the wiring to a switch
and power source (not included). Basic knowledge of low voltage
systems will be required. These parts do not come with instructions, however
installation/integration is very easy-just take the two wire leads (+ and -)
and wire into your existing system. Countless hours have been spent designing,
producing, testing and assembling these parts to make them not only easy to
install, but also to provide the most realistic looking parts at the most
reasonable price point possible. Each one of these parts is 3D printed, but
each LED is set and wired by hand. Depending on supply vs. demand, there may be
a 5-10 BUSINESS DAY handling time to produce and assemble, not including the
time to actually ship the item. If a quicker turnaround is required, please
send me a message prior to purchasing with the exact quantity needed so I can
see if it is something that can be accommodated.