DO-IT-YOURSELF.

If you’re using these moulds to make coasters, we recommend that you add a 3mm thick clear layer of Heat-Resistant resin first in your mould. Let it set and then add more resin with colour, ink, glitter, flowers etc. Once turned out (after 3-4 days), what was the bottom will be the top and heat-resistant up to 20oC! Remember that our Heat-Resistant resin needs between 72 h to achieve full cure, so don’t place a hot cup on it too early.

Warning: do not use aggressive solvents, High-quality moulds, heat-resistant: -40°C to + 210°C [-104° F to +410° F]

Attention! Remove the product from the mold no later than 12 hours after pouring the resin. Otherwise, there is a chance of local adhesion of the resin to the mold.

The size of the silicone mold:

Bottle Holder + 2 coasters Mould Set:

Bottle holder –255 x 105 mm (1pcs) + Coaster –D. 130 mm (2pcs)

“AGATE GEODE” – 1 set /6pcs:

Dimensions: 32.2 x 26.7 cm

Partially: 1#(10.8 х 10.5 cm); 2#(9.3 х 9.8 cm); 3#(9.5 х 9.1 cm); 4#(10.5 х 9.5 cm); 5#(9.3 х 10.3 cm); 6# (10.5 х 9.5 cm).

Fruit Holder Silicone Mould Set:

Silicone molds:
D. 155mm – 1pcs
D. 205 mm – 1pcs
D. 255 mm – 1pcs

Support rod (by variation)!
110mm – 2pcs
122mm x P. 47 – 1pcs

“FOUR IN ONE” – Silicone Coaster Mould – ⌀21cm:

D.21 cm
Height: 0.8cm

Cutting Board Moulds-With edges
Dimensions:
34,5 × 19 cm
Thickness 2,5 cm

Cutting Board Moulds-Without edges
Dimensions:
35 cm x 21 cm
Thickness 2,5 cm

“PYRAMID” – Silicone Mould
Glass measures: 11 x 11 CM / H. 6. 5 CM

“TRAY” – Silicone Mould
30.5 cm x 17 cm x 1 cm

Bottle Holder 
12×25cm

“LARGE MINERAL” – Silicone mould:
№1 -8 x 6,5 x a3
№2 - 3.1 x 3.9 CM
№3 -D. 3. 5 CM / H. 4 CM